Automec CNC9x9 Backgauge System

The CNC9x9 backgauge system is a simple-to-use 9 bend, single axis system that was developed as a low cost solution to be used with Automec’s series of backgauges for pressbrakes. The system comes with a two year warranty.

The typical CNC9x9 user bends simple parts. The system can be used for single bend “go to” positioning or sequential bending of up to 9 bends with up to 9 repeats of identical bends.

The CNC9x9 backgauge system retains the same speed, accuracy, and repeatability as provided by Automec’s higher end controls at a more affordable price. The system also features bend allowance and inch/mm conversion. The operator can display backgauge position, bend number, and cycles per bend. Error messages appear when unattainable dimensions are entered and all backgauge dimensions can be offset ± .999” with one data entry.

The CNC9x9 backgauge system consists of a mechanical gauging mechanism, controller, gauge bar, (2) flip fingers, instruction manual, interconnect cables and mounting hardware.

The CNC9x9 is also offered as a control only upgrade for our customers looking to replace their old G24 controls.

Control Specifications

• 2 - Ram Depth Modes: Ram display can show true ram position in Depth or Angle.
• Ram Offset - All ram dimensions can be offset ± .393” with one data entry.
• Gauge Offset - All backgauge dimensions can be offset ± .393” with one data entry.
• 300 Jobs (00 to 299)
• 10 Bends per Job (linking available)
• 11 Digit Job Number
• Tool Library
• Depth or Angle Mode
• Programmable Delay/Retract between Bends (0 - 19 sec.)
• Programming delay/retract between bends (0 – 9 seconds)
• Bend allowance ± .393”
• Calculator to change dimensions incrementally
• Angle Adjust for Angle Correction
• Backgauge Reversal on Pinch Point (time and distance)
• Parts counter
• Single Entry Ram Offset and Bend Allowance Included
• RS232 Interface and Software
• Automatic Ram Calibration to Tool Heights
• 1, 2, or 3 axis
• .001” resolution
• Red L.E.D. display
• IN/MM conversion
• Membrane Keyboard
• 30-day battery back up
• 20", 24” or 48” Backgauge
• Input power - 115 VAC ± 10% 50/60 HZ, 1A MAX (Control)
• 2 year control warranty

Click on the "Backgauges" button below to see a complete list of backgauges available for the CNC9X9 or click on the "Brochure" or "Price Sheet" buttons to download PDF versions of our brochure or price sheets. If you don't have Acrobat Reader installed on your system, please click here:

Download Free Adobe Acrobat Reader