(Download numerical control customization)
16) NUMERICAL CONTROL CUSTOMIZATION
The” numerical control customization operation configures the numerical control in relation to the number of axes used.
In case of the ERROR 00 or ERROR 80 message, it is advisable to check that this configuration is correct
16 -1 METHOD OF ACCESS
16-2 Key Values
Along X axis: number of axes installed:
1 = X
2 = X+Y
3 = X + Y + R or Z
4 = X + R or Z
Along Y axis:
- the Y count decreases when the press is closed
- Reverse counting (not used).
Along AUX axis:
- adjustment on FC-(R axis)
- adjustment on FC +(Z axis)
Along–> t: Multiplication factor
- on R axis
- on Z axis
Along M: End-of-travel value =
- 200 on R axis
- 60 on Z axis
Along: Number of parts between two position resets of AUX axis. It is recommended that this value be set to zero
16 – 3 METHOD OF CHECKING
16 – 4 METHOD OF WRITING
BACK TO AMADA PROMECAM HYDRAULIC PRESS BRAKE TECHNICAL MANUAL
Back to 15) – Amada Promecam use of numerical control (Type MB)
Continue to 17 – PROGRAMMING Amada Promecam ITS
Download the full Amada Promecam ITS Hydraulic Press Brake 45899 Manual
About Automec, Inc.
If you are having issues with your Press Brake and need a Backgauge Control Upgrade Kit you have come to the right place. Automec is the industry leader in Retrofitting Pressbrakes and Shears.
Our positioning systems consist of a programmable control where the operator enters a dimension and a motorized gauging mechanism automatically moves through a sequence of programmed dimensions. These systems can be retrofitted to press brakes, shears, cut-off saws and punches.
Whether you need a press brake retrofit or a new press brake, contact us at (781) 893-3403 for help.