Amada Promecam Press Brake Installation

5.1 -INSTRUCTIONS PRIOR TO HANDLING AND INSTALLATION

 

5.1.1 – PREPARATION OF THE INSTALLATION FLOOR

Once the location is prepared for your Amada Promecam installation, carefully sweep the area to be occupied by the press.

5.1.2 – FORBIDDEN OPERATIONS

In no case should handling accessories (slings, hooks, straps, etc.) be attached to the following
components:
– Upper beam
– Lower beam
– Electrical cabinet
– NC Cabinet
– Bending Depth control (ITS)
– Pressure limiter (ITS)
– Mechanical protectors on:
– Goose neck
– back of machine
– Hooding
– Back gauge
Please see section 5.3.2 to identify the areas recommended for floor support.

5.2 – HANDLING

5.2.1 – BASIC PRINCIPLES

The lifting efforts should only be applied at the slinging points provided for this purpose (Fig. 5.2).

Amada Promecam Press Brake Installation Load distribution

Add approximately 500 Kg if your machine is fitted with a numerically controlled back gauge.

5.2.2. – HANDLING ACCESSORIES

The handling operations for your Amada Promecam installation are to be performed as follows:
a) Use lifting means such as traveling bridges or cranes.
Use the slinging point (40 mm diameter holes on each upright). These holes can directly receive
the shackles where the lifting slings will be secured.
b) If no appropriate lifting equipment is available the press may be moved on small tractors
(Fig 5.3).

Amada Promecam Press Brake Installation Fig 5.3

In this case, carefully comply with the allowed bearing points:
amada promecam bearing points

IMPORTANT

ANY HANDLING OR SELECTION OF BEARING/ANCHORING POINT OTHER THAN
THOSE SHOWN ON THE ABOVE DIAGRAMS ARE FORBIDDEN. ANY INCIDENT
RESULTING FROM NON-COMPLIANCE WITH SUCH INSTRUCTIONS MAY RESULT IN
SUSPENSION OF THE GUARANTEE.

BACK TO AMADA PROMECAM HYDRAULIC PRESS BRAKE TECHNICAL MANUAL

Back to AMADA PROMECAM ENVIRONMENTAL PREPARATION

Continue to 6) LEVELING OF THE MACHINE

Download the full Amada Promecam ITS Hydraulic Press Brake 45899 Manual