Automec’s Top Customer Service Questions

1. Where can I find the serial number (SN) for my Automec system? The serial number is an eight digit number that is located on the back of the control and the backgauge motor pack. Note: on the CNC99 control the serial number can be found on the front of the control underneath the “quick

Read More »
Adjustment of Dimension E on Dial Gauge 2

18) – Amada Promecam Routine Maintenance Operations

(Download promecam press brake machine maintenance) 18 -1 MACHINE MAINTENANCE: Your press requires a minimum amount of maintenance; maintenance is chiefly limited to draining the hydraulic system. A) HYDRAULIC SYSTEM – DRAINAGE The hydraulic system in your press has distributor valves. The reliability of these valves depends above all on how clean the oil is.

Read More »
programming - fig. 1

17) – PROGRAMMING Amada Promecam ITS

(Download programming Amada Promecam press brake ITS) 17 -1 PROGRAMMING OF A PART 17 – 2 PROGRAMMING OF BENDS In the case of a 3-axis MB3 numerical control, program the dimension of the R axis or the Z axis, using: 17 ·3 FINDING PINCH DIMENSION   17 – 3 – 1 IN MANUAL MODE Position

Read More »
Method of Access

16) Amada Promecam Numerical Control Customization

(Download numerical control customization) 16) NUMERICAL CONTROL CUSTOMIZATION The” numerical control customization operation configures the numerical control in relation to the number of axes used. In case of the ERROR 00 or ERROR 80 message, it is advisable to check that this configuration is correct 16 -1 METHOD OF ACCESS 16-2 Key Values Along X

Read More »


(Download Use of numerical control type MB) 15 – 1 PRELIMINARY OPERATIONS – Start-up: refer to section 11.2. – The type of numerical control and the date of the software program are displayed for a few seconds (24). This display is followed by another, indicating the number of startups. – The flashing entry START appears

Read More »


Contact Us

Scroll to Top