(Download putting machine into service) Commissioning of the machine is ensured by our Technical Department. For commissioning, prepare some sheet metal plates for testing: 200 mm wide strips, length depending on your machine capacity. Select sheet metal nature and thicknesses generally used for your production requirements. IMPORTANT: AS WE ENSURE INITIAL START UP OF THE […]
7) PROMECOM PRESS BRAKE COMMISSIONING Read More »
Carefully follow the procedure given below to level your machine correctly. Provide two 150 X 150 X 5 mild steel shims According to the date on which the machines are manufactured, screws refs. 1 can be located either inside or outside the frame. With the machine laid directly on the floor, test its horizontality with
6) Leveling the Amada Promecam Press Brake Read More »
5.1 -INSTRUCTIONS PRIOR TO HANDLING AND INSTALLATION 5.1.1 – PREPARATION OF THE INSTALLATION FLOOR Once the location is prepared for your Amada Promecam installation, carefully sweep the area to be occupied by the press. 5.1.2 – FORBIDDEN OPERATIONS In no case should handling accessories (slings, hooks, straps, etc.) be attached to the following components:
5) Amada Promecam Press Brake Installation Read More »
How to prepare your machine shop, space, and environment before installing your Amada Promecam press brakes.
4) Amada Promecam site and environmental preparation Read More »
This section outlines the Amada Promecam Installation Requirements 3.1 – AMADA PROCAM PRESS BRAKE ELECTRICAL CONNECTION The proper operation of an electrical system depends on the quality of the power supply, it should be stable and free of disturbances. Your Amada Promecam Installation should be planned and carried out so as to meet current
3) AMADA PROMECAM PRESS BRAKE INSTALLATION REQUIREMENTS Read More »
Amada Press Brake Safety Guidelines for Promecam Machines 2.2 RULES FOR SAFE OPERATION OF YOUR AMADA PROMECAM PRESS BRAKE 2.1 CONFORMITY Press brakes are shipped from the factory with basic safety equipment including: A double foot pedal (close/open). A switch-operated mode selector. Lateral protection Back protection Self-supervising electrical and hydraulic circuits Optional: equipment for a
2) Amada Press Brake Safety Guidelines for Promecam Machines Read More »
This document is designed to facilitate the handling, placing operations and connection to the electricity and compressed air supply networks of your ITS or ITPS hydraulic press brake (Figure 1.1). This publication covers the following models: AMADA ITS 50/12 AMADA ITS 50/20 AMADA ITS 80/25 AMADA ITS 103 AMADA ITS 125/30 List of available versions:
1) AMADA PROMECAM HYDRAULIC PRESS BREAK MANUAL GENERAL INTRODUCTION Read More »